-
[x] Search for OT for the first 50 15 mins with a delay of 5min (still waiting on that)
-
[x] Wifi is lost
- [x] Continue with current setpoint of the weekly program if available
- [x] If weekly program is disabled : continue with the last setpoint
- [x] If there is an external error just set curr_temperature to antifreeze one
-
[x] Check the On/Off switching based on the documentation sent
-
[x] Fill up the Change Request (CS) after Jeremy's ping
-
[ ] Prepare block-diagram for the sensor measurements and send it
- [x] Take a look at what exactly Francois needs
- [ ] Maybe explain it a bit in the SPD for the temperature algorithm
- [ ] Explain the tolerance of the temp sensor
-
[x] Change request with Wi-Fi password as well
-
[x] Fix the UART output functionality
- [x] Change the log to only log the firmware version
- [x] Ensure that it works with the nightly device
- [x] Do an AET test to check that everything passes fine
-
[x] Change Log
- [x] Add all the version changes to Francois document
-
[x] Add AP password change to the SPD
-
[x] Firmware Update
- [x] Check that firmware update can be performed with the new version
- [x] Check that more tasks can be disabled during FW
- [x] Fix tests for FW update
- [x] Fix FW update when in debug mode
-
[x] Display changes
- [x] When factory reset set default display duty cycle to 50
<aside>
⚡ When factory reset duty cycle goes back to default which is 67%
</aside>
- [x] Check that duty cycle is correct based on the tests available in firmware
- [x] Check the flame works correctly when working in normal mode
-
[x] Weekschedule
- [x] Ensure that when factory-reset the default temperature is set to nvs
- [x] Fix the test comments for 70/07 to match the actual test
-
[ ] Send firmware with humidity change to backend for Francois and Tom, ask Paul for update request
-
[x] Ask Paul backend dev is down or if the certificate that I have been using is the wrong one